Home > Knowledge > Content

Composition of hydraulic cylinder

Jul 18, 2023

The hydraulic cylinder is basically composed of five parts: cylinder and cylinder head, piston and piston rod, sealing device, buffer device and exhaust device.

 

1. Cylinder and cylinder head

In general, the structural form of cylinder and cylinder head is related to the material used. Working pressure p< 10MPa, use cast iron; p< At 20MPa, use seamless steel pipes.

2. Piston and piston rod

The piston rod and piston of a short stroke hydraulic cylinder can be made into one, which is the simplest form. However, when the stroke is long, the processing of this integral piston assembly is more difficult, so the piston and the piston rod are often manufactured separately, and then connected into one.

3. Buffer device

Hydraulic cylinders are generally set buffer device, especially for large, high-speed or demanding hydraulic cylinders, in order to prevent the piston at the end of the stroke and cylinder head impact each other, causing noise, impact, you must set buffer device.

The working principle of the buffer device is to use the piston or cylinder to seal part of the oil between the piston and the cylinder head when it goes to the end of the stroke, forcing it to extrude from the small hole or thin seam to produce a lot of resistance, so that the working parts are subjected to braking, gradually slowing down the movement speed, to avoid the purpose of the piston and the cylinder head hitting each other. The structure of the common buffer device includes annular gap type, orifice area variable type and orifice area adjustable type.

4. Sealing device

The leakage of oil in the high pressure chamber of the hydraulic cylinder to the low pressure chamber is called internal leakage, and the leakage of oil in the hydraulic cylinder to the outside is called external leakage. Due to the internal leakage and external leakage of the hydraulic cylinder, the volumetric efficiency of the hydraulic cylinder is reduced, which affects the working performance of the hydraulic cylinder, and the system pressure does not rise or even cannot work in serious cases. And external leakage will also pollute the environment, so in order to prevent leakage, the place that needs to be sealed in the hydraulic cylinder must take corresponding sealing measures. The parts that need to be sealed in the hydraulic cylinder are: piston, piston rod and end cap.

5. Exhaust device

When the hydraulic cylinder is installed or parked for a long time to work again, air will penetrate into the hydraulic cylinder and pipeline system. In order to prevent the abnormal phenomenon of crawling, noise and heating of the actuator, the air in the cylinder and system must be discharged. Generally, the oil inlet and outlet can be set up at the highest point of the hydraulic cylinder to take away the gas, and the exhaust hole or special exhaust valve can also be set up at the highest point.

 

Send Inquiry