1. Disassembly. For the hydraulic valve, although most of its parts are connected by bolts, but the hydraulic valve in the design of non-disassembly, if the lack of special equipment or lack of professional technology and forced disassembly, the result may lead to damage to the hydraulic valve. Therefore, maintenance personnel should master the hydraulic valve structure before disassembly, and should master the connection mode between each part, and record the position relationship between different parts in the disassembly process.
2. Check and clean. Check the valve body and valve core and other parts to observe the dirt deposition. On the basis of not causing damage to the working surface, use the brush, cotton yarn and non-metal scraper to remove the concentrated dirt.
3. Rough cleaning. The valve core and the valve body are placed on the cleaning box tray, and the valve is heated and soaked. The compressed air is passed into the bottom of the cleaning tank, and the stirring effect generated by the bubbles is used to clean the residual dirt. The ultrasonic cleaning is feasible when the conditions permit.
4. Fineness. First, the cleaning solution is used for high pressure positioning cleaning, and then dry with hot air. In the enterprise conditions, can choose the existing freshener, in some special occasions can also be used for organic cleaning agents, such as gasoline and diesel, etc.
5. Assembly. Assemble according to the diagram of the hydraulic valve or the assembly relationship of the parts recorded during the disassembly. Careful operation should be paid attention to during the assembly process to prevent the parts from being damaged. For some original sealing materials, it is easy to be damaged in the actual disassembly process, so it should be replaced during assembly.








