1. Introduction of Rockwell hardness
Rockwell hardness is an index to determine the hardness value by the depth of plastic deformation of the indentation, with 0.002 mm as a hardness unit, expressed as HR. The use of different indenters and different test forces in Rockwell hardness tests results in different combinations (HRA to HR45Y) that correspond to different Rockwell hardness scales. There are three rulers in common use, and their applications cover almost all commonly used metal materials.
These three scales are A, B, C, that is, HRA, HRB, HRC, according to the hardness of different experimental materials, choose different hardness ranges of scales to indicate:
First, HRA is the hardness obtained by using 60Kg load and diamond cone indenter, which is used for materials with higher hardness. For example: steel sheet, carbide.
Second, HRB is the hardness obtained by using a 100Kg load and a hardened steel ball with a diameter of 1.5875mm, which is used for materials with low hardness. For example: mild steel, non-ferrous metal, annealed steel, etc.
Third, HRC is the hardness obtained by using 150Kg load and diamond cone indenter, which is used for materials with higher hardness. For example: hardened steel, cast iron, etc.
Note: Lowe hardness value is "nameless number", there is no unit. Therefore, it is not correct to call the number of degrees of Luo hardness. Its expression method is hardness data + hardness symbol, such as 50HRC.
2. Introduction of Vickers hardness
Vickers hardness is a measure of the hardness of a material. It was first proposed by British scientist Vickers and is represented as HV. Vickers hardness test is mainly used in material research and scientific testing of small load Vickers hardness test, mainly used to test the hardness of small precision parts, the hardness of the surface hardened layer and the depth of the effective hardened layer, the surface hardness of the coating, the hardness of the sheet material and the hardness of the fine wire, the hardness near the blade, the hardness of the dental material, etc. Since the test force is small and the indentation is small, the appearance and performance of the sample can not be affected.
The Vickers hardness tester can measure almost all metal materials used in industry, from very soft materials (a few Vickers hardness units) to very hard materials (3000 Vickers hardness units).
The value in front of HV is the hardness value, and the value behind is the test force. If the test force holding time is not the usual 10-15 seconds, the holding time should be marked after the test force value. For example: 600HV30/20 means that the test force of 30 kg force is used, held for 20 seconds, and the hardness value is 600.
3. Difference between Rockwell hardness and Vickers hardness
Rockwell hardness: easy to operate, direct reading, and small indentation, suitable for batch and finished product production, but need multi-point testing to ensure accuracy. The Vickers hardness test has a wide measurement range, from softer materials to superhard materials, covering almost all kinds of materials.
Rockwell hardness: suitable for metals with high hardness, such as various alloy steels after heat treatment, etc., requiring high test surface flatness. Vickers hardness is suitable for accurately measuring the hardness of micro-areas, usually used to detect the effective hardening layer after metal carburizing, requiring a very high test surface flatness, must be a polished surface.






