Home > Knowledge > Content

Pressure relief mode of hydraulic control check valve

Nov 27, 2023

The hydraulic system often uses the hydraulic control check valve, so how much do you know about the pressure relief mode of the hydraulic control check valve?

① In the oil flow reverse outlet without back pressure in the oil circuit can be selected, otherwise choose the leakage type to reduce the pressure of the control oil, and the leakage type of the oil outlet must be no pressure back oil, otherwise it will offset part of the control pressure.

② When there is back pressure at the outlet of the hydraulic control check valve, the leakage type should be selected, and the internal leakage type can be selected in other cases. Some lifting platform hydraulic systems, because the design is not considered, should use the leakage type hydraulic control check valve, but choose the internal leakage type, which causes the system to have strong vibration and noise.

③ Internal and external hydraulic control check valves are respectively used in situations where the back pressure of the oil flow in the reverse outlet mouth is low or high to reduce the control pressure. For example, the hydraulic system hydraulic control check valve is installed in the rear of the one-way throttle valve, the oil flow in the reverse outlet chamber is directly connected to the tank, the back pressure is small, and the internal drain structure can be used. If the hydraulic control check valve is installed in the front of the one-way throttle valve, the reverse oil outlet chamber returns to the tank through the one-way throttle valve, and the back pressure is high, it is necessary to use the leakage structure.

How much do you know about the pressure relief mode of hydraulic control check valve? Hydraulically controlled check valve

④ In the case of high pressure oil in cavity B, and it is impossible to establish A large back pressure in cavity A (such as directly connected to the fuel tank), use a hydraulic control check valve with unloading valve spool, because after the unloading valve spool is opened, the flow area at the unloading valve is very small, the pressure of the high-pressure oil source in cavity B still cannot be unloaded, and the high pressure still acts on the upper cavity of the main valve spool, pressing the main valve spool on the seat. In this way, the control piston still needs to control the oil pressure to open the main spool.

⑤ When the hydraulic control check valve leads the spool away from the control piston, so that the reverse oil flow passes through, the control oil is removed, the control piston returns, and the valve spool is updated and closed, the oil in the control piston cavity is discharged from the control oil port. If the back pressure of the control oil return is high and the oil discharge is not smooth, the control piston can not return quickly, and the closing speed of the valve core is also affected, which cannot meet the requirements of the hydraulic system that needs to quickly cut off the reverse oil flow. To this end, the hydraulic control check valve of the leakage structure can be used to introduce the pressure oil into the leakage port and force the control piston to return quickly.

 

Send Inquiry