General precautions for the use and maintenance of hydraulic systems
1. The operator should be familiar with the use of the host and the principle of the hydraulic system, master the system action sequence, and the adjustment method of the hydraulic components.
2. Before starting the equipment and during the operation of the equipment, the state of the machine should be checked.
3. The correct use and maintenance of hydraulic working media.
The pollution of hydraulic oil is the main fault source of the hydraulic system. To this end, it should be noted that the hydraulic working medium (hydraulic oil) should be stored in a special place, and the required appliances (such as oil drums, funnels, tubing, rags, etc.) should be kept closed and clean; It is best to use silk or chemical fiber fabrics to scrub, so as not to block the small pores of the components, failing; The fuel tank should be sealed, and the filter element of the filter should be checked, cleaned and replaced frequently; Check frequently and change the oil regularly according to the working condition. Generally, after 1000 hours of accumulated work, the oil should be changed. Intermittent use should be half a year or a year, according to the working situation oil change. The oil tank should be cleaned when changing oil, and then inject new oil into the oil tank through the oil filter of more than 120 mesh; The oil pipe should be soaked in oil for 24 hours to generate an inactive film before use; Assembly and disassembly components must be cleaned to prevent pollutants from falling into; When the hydraulic oil is seriously polluted, the cause should be identified in time and filtered or replaced.
4. The oil temperature of the hydraulic system should be controlled within a certain range
At low temperature, the oil temperature should reach 20℃ or more before the sequential action is allowed; When the oil temperature is higher than 60 ° C, attention should be paid to the working condition of the system (pressure, flow).
The high oil temperature will increase the leakage of the hydraulic system, deteriorate the stability, and even affect the machining accuracy of the main machine. To this end, attention should be paid to: maintain the correct liquid level in the tank, so that the working medium in the system has sufficient circulating cooling conditions; Correctly select the viscosity of the hydraulic working medium, and keep it clean, in addition, the working medium should be replaced on schedule; In the intermittent operation of the system, the hydraulic pump should be unloaded during the waiting period; Keep the water cooler full of water and the pipes clear.
5. Prevent air from entering the system.
Air entering the hydraulic system will affect the working stability of the actuator components and cause system vibration and noise.
To this end, it should be noted that the liquid level in the tank should be checked frequently to keep it between the lowest and highest levels of the level gauge. At the lowest level, the suction pipe mouth and the return pipe mouth should also be kept below the liquid level and separated by a partition; Should try to prevent the pressure in the system is lower than the atmospheric pressure, at the same time to use a good sealing device, failure should be replaced in time, pipe joints and the screws at the joint surface should be fastened properly, should be cleaned in time air filter; Exhaust the air from the system promptly through the exhaust valve (plug).






